CMM Dimensional Inspection for Die Castings

Definition of CMM Dimensional Inspection for Die Castings

CMM dimensional inspection for die castings is the measurement of a cast part's geometry on a coordinate measuring machine. The machine moves a touch probe, or on some systems an optical sensor, over the part and records the position of each point it contacts in three axes. Software fits these points to features such as planes, bores and bosses, and compares them with the 3D model or the drawing.

Results are reported as deviations from nominal dimensions and as geometric tolerances such as flatness, position and profile, defined under ISO 1101 or ASME Y14.5. A bridge-type machine, the common design in which the probe travels on a gantry over a granite table, typically measures to within a few microns. That is well inside the tolerances held on cast or machined aluminum. The method is used for first article inspection, process setup and periodic checks of critical dimensions.

Why This Matters for Your Business

A CMM report is the evidence that most customers and auditors accept as proof that a casting matches its drawing. It carries weight at first article approval, in a production part approval process (PPAP) submission, and in any later disagreement over whether a lot conforms. Its value depends on the supplier measuring from the same datums that you use. If the part is aligned one way on the supplier's machine and another way on yours, both reports can be correct and still disagree, and the parts wait in quarantine while the two programs are compared.

Machine time is the main cost. Measuring every feature on every casting is rarely economical, so most suppliers use the CMM for first articles and periodic audits, and check critical features in production with dedicated gauges. If the drawing does not show which dimensions are critical, the supplier has to guess, and the inspection plan in the quotation may not match what you expect.

We would suggest marking critical and significant characteristics on the drawing, stating the report format you need and agreeing the measurement frequency before the tooling order. The inspection cost is then included in the unit price from the start.

FAQ

What CMM capability should I expect from a qualified aluminum die casting supplier?

You should expect at least one CMM with a measuring volume large enough for your biggest part, installed in a room held close to 20 °C, the reference temperature set by ISO 1. Temperature control matters more for aluminum than for steel. Aluminum expands by about 23 microns per meter for each degree Celsius, so a 200 mm casting measured 5 °C warm reads roughly 0.02 mm long. Please ask who writes the programs, whether they are built from your 3D model, and for a sample report from a similar part. ISO 9001 requires measuring equipment to be calibrated, so a supplier's ISO 9001:2015 certification should cover the machine itself.

How often should critical dimensions on a die cast part be checked on the CMM during production?

Critical dimensions are normally measured on the first articles, again after any die repair or maintenance, and then on a small sample at set intervals, often the first parts of each shift or each lot. Where a dimension holds a process capability index (Cpk) of 1.33 or better, the interval can be lengthened. Our article on inline quality inspection explains how checks during production support batch accuracy.

How is a CMM program written for a complex aluminum casting, and which datums does it reference?

The program is usually written offline from the 3D model, in software such as PC-DMIS or Calypso. It begins by aligning the part to the datum reference frame on the drawing. The primary datum is normally a large flat face contacted at three or more points. The secondary datum, often a bore or an edge, fixes rotation, and the tertiary datum fixes the last direction of movement. On a raw casting these are often datum targets, small defined pads on the as-cast surface, because machined faces do not yet exist. After machining, the program usually switches to machined datums, so the drawing should state which set applies at each stage. The same scheme should govern the fixtures used in CNC machining, so that the part is held and measured from the same references.

Unite Kingdom Flag
English
Japan Flag
日本語
Taiwan Flag
繁體中文
Star Icon

AI Assistant Coming Soon!

This feature is currently under development. We are excited to launch this service shortly to better support your manufacturing inquiries.